Dater with textplate, model D53V

To insert the inkpad → Fig. 1 + 3
Note: Use only oil-containing stamp ink.
Handle with caution to avoid dirt from ink!

> Press the handle A to the bottom of its travel, then while still holding it.
> Press the button B on the front plate and continue to hold it pressed.
> Allow the handle A to move upwards until the handle locks in place.
> Unpack the inkpad carefully.
> Squeeze the grips F on the back of the inkpad and hold them.
> Resting the back of the ink pad inside the pad cradle slide the pad into the slot F of the stamp.
> In order to return to the print position, simply push down on handle E.

To park the stamp → Fig. 5
To prolong the life of the inkpad, park the stamp!

> Press and hold button B on the front plate.
> Gently push handle A downwards until the stamp clicks & locks in a raised position.
> In order to return to the print position, simply push down on handle A.

Note
Some REINER models feature a metal locking plate sitting inside the outer frame, or some older designs have a locking pin placed at the spring tube below the handle.

Unlocking the stamp → Fig. 5

> In order to return to the print position, simply push down on handle A.

Note
Press back locking pin – e.g. model TA, K1.

To set the stamp wheels → Fig. 1 + 2
Example B6

> Press the handle A to the bottom of its travel, then while still holding it.
> Press and hold button B on the front plate.
> Allow the handle A to move upwards until the handle locks in place.
> You will be able to move the stamp wheels D freely with the stylus C.

You can hide preceding zeros in a number!
Example: 49 instead of 000049

> To do this move the stamp wheels D with the adjusting pin C to the empty spaces between “0” and “1”.
> In order to return to the print position, simply push down on handle A.

Note
REINER date stamps feature a lever mechanism to move the date forward day by day. This lever may also be used to adjust the setting of the wheels. Just press down the lever.

Preceding zeros → Fig. 2
Example: 49 instead of 000049

> Turn the stamp wheel D with stylus C to digit position “0”.
> Using stylus rotate and push down on stamp wheel through a half digit position until it sinks below print height.
> To return to the print position, simply push down on handle A.

Exceptions: Mod. B6, B6K, ND6K
Have no drop wheels. You may remove the zero from printing by turning the wheel “half way” to “1”.

> To do this move the stamp wheels D with the adjusting pin C to the empty spaces between “0” and “1”.

Note
Date stamps do not feature wheels that can retract.

REINER date stamps in general feature a lever to set the date. Just press the lever to turn the wheels.

Alternatively use a stylo and refer to “How do I adjust the number or date” an “How do I lock a stamp in its parking position”.